WaveSplitter | Lighting the Internet on Fiber
             

WST-QSFP-AOCc-Cxx

142 views
0 Likes
0 0
40GBase QSFP+ Active Optical Cable

Share on Social Networks

Share Link

Use permanent link to share in social media

Share with a friend

Please login to send this document by email!

Embed in your website

Select page to start with

4. All contents are Copyright © 1996 - 2015 Wavesplitter Technologies, Inc. All rights reserved. Preliminary and Proprietary www.wavesplitter.com Page 4 of 5 Documen t Number: 95 - 00 85 - V 1.0 4 0GBase Q SFP+ Active Optical Cable WST - Q SFP+ AOC c - C xx Me chanical Dimensions (mm)

3. All contents are Copyright © 1996 - 2015 Wavesplitter Technologies, Inc. All rights reserved. Preliminary and Proprietary www.wavesplitter.com Page 3 of 5 Documen t Number: 95 - 00 85 - V 1.0 4 0GBase Q SFP+ Active Optical Cable WST - Q SFP+ AOC c - C xx 12 LVCMOS - I/O SDA 2 - wire serial interface data 3 3 13 GND Ground 1 1 14 CML - O Rx3p Receiver Non - Inverted Data Output 3 15 CML - O Rx3n Receiver Inverted Data Output 3 16 GND Ground 1 1 17 CML - O Rx1p Receiver Non - Inverted Data Output 3 18 CML - O Rx1n Receiver Inverted Data Output 3 19 GND Ground . 1 1 20 GND Ground . 1 1 21 CML - O Rx2n Receiver Inverted Data Output 3 22 CML - O Rx2p Receiver Non - Inverted Data Output 3 23 GND Ground 1 1 24 CML - O Rx4n Receiver Inverted Data Output 3 25 CML - O Rx4p Receiver Non - Inverted Data Output 3 26 GND Ground 1 1 27 LVTTL - O ModPrsL Module Present 3 4 28 LVTTL - O IntL Interrupt 3 4 29 VccTx +3.3 Power Supply transmitter 2 2 30 Vcc1 +3.3 Power Supply 2 2 31 LVTTL - I LPMode Low Power Mode 3 32 GND Ground 1 1 33 CML - I Tx3p Transmitter Non - Inverted Data Input 3 34 CML - I Tx3n Transmitter Inverted Data Input 3 35 GND Grou nd 1 1 36 CML - I Tx1p Transmitter Non - Inverted Data Input 3 37 CML - I Tx1n Transmitter Inverted Data Input 3 38 GND Ground 1 1 Notes: 1. GND is the symbol for signal and supply ( power) common for QSFP module . All are common within the QSFP module and all module voltages are referenced to this potential unless otherwise noted. Connect these directly to the host board signal - common ground plane. 2. Vcc Rx, Vcc1 and Vcc Tx are receiver and transmitter power supplies and shall be applied concurrently. Requiremen ts, defined for the host side of Host Edge Card Connector, are listed in Table 6. Recommended host board power supply filtering is shown in Figure 4. Vcc Rx, Vcc1 and Vcc Tx may be internally connected within the QSFP transceiver module in any combination. The connector pins are each rated for a maximum current of 500mA. 3. SDA and SCL pins should be pulled up with a 4.7Kohm to 10Kohm resistor on the host board. 4. ModPrsL and IntL pins should be pulled up with a 4.7Kohm to 10Kohm resistor on the host board.

1. Data Sheet All contents are Copyright © 1996 - 20 1 5 Wavesplitter Technologies, Inc. All rig hts reserved. Preliminary and Proprietary www.wavesplitter.com Page 1 of 5 4 0GBase Q SFP+ Active Optical Cable WST - QSFP+AOC c - Cxx Absolute Maximum Ratings Parameter Symbol Unit Min Max Storage Temperature Range T s o C - 40 +85 Power Supply Voltage V cc V 0 +3.6 Relative Humidity RH % 5 95 Recommended Operating Conditions Parameter Symbol Unit Min Typ Max Case Operating Temperature Range T c - CT o C 0 25 +70 Power Supply Voltage V cc V 3.135 3.3 3.465 Power Supply Current I cc mA 475 Power Consumption W 1 .5 Data rate per Channel Gbps 10.3125 Maximum Aggregate Data Rate Gbps 40 Features:  Link Distance Up to 100m over OM3 MMF  4 channel 850nm VCSEL and PIN type detector  Single 3 .3V and high speed AC - Couple d  SFF - 8436 QSFP+ compliant design  Supports Infiniband SDR, DDR and QDR  O perating case temperature range: 0 °C~7 0 °C  RoHS Compliant Applications:  40G Ethernet (40GbE)  High - speed interconnections

2. All contents are Copyright © 1996 - 2015 Wavesplitter Technologies, Inc. All rights reserved. Preliminary and Proprietary www.wavesplitter.com Page 2 of 5 Documen t Number: 95 - 00 85 - V 1.0 4 0GBase Q SFP+ Active Optical Cable WST - Q SFP+ AOC c - C xx S pecifications (tested under re commended operating conditions, unless otherwise noted) Electrical T ransmitter Characteristics Parameter Symbol Unit Min. Typ. Max. Notes Data Input Differential Voltage Swing mVp - p 500 1200 Electrical R eceiver Characteristics Parameter Symbol Unit Min. Typ. Max. Notes Bit Error Ratio per Lane BER 10 - 12 10.3125Gbps, PRBS31 Data Output Differential Voltage Swing mVp - p 0 1000 QSFP AOC Pad Layout Pin L ogic Symbol Description Plug Sequence Notes 1 GND Ground 1 1 2 CML - I T x2n Transmitte r Inverted Data Input 3 3 CML - I Tx2p Transmitter Non - Inverted Data Input 3 4 GND Ground . 1 1 5 CML - I Tx4n Transmitter Inverted Data Input 3 6 CML - I Tx4p Transmitter Non - Inverted Data Input 3 7 GND Ground 1 1 8 LVTTL - I ModSelL Module Select 3 9 LVTTL - I ResetL Module Reset. 3 10 VccRx +3.3 Power Supply Receiver 2 2 11 LVCMOS - I/O SCL 2 - wire serial interface clock 3 3

5. Page 5 of 5 Documen t Number: 95 - 00 85 - V 1.0 4 0GBase Q SFP+ Active Optical Cable WST - Q SFP+ AOC c - C xx Ordering Information Part No Specification Package Data rate Fiber Cable Type Cable Length Temp . Application WST - Q SFP+ AOC - C 01 Q SFP+ 4x 10.3 Gbps OM2 Ribbon OFNP 1m 0~70 o C 40GbE Infiniband SDR,QDR,DDR WST - Q SFP+ AOC - C 03 Q SFP+ 4 x 10.3 Gbps OM2 Ribbon OFNP 3m 0~70 o C 40GbE Infiniband SDR,QDR,DDR WST - Q SFP+ AOC - C 05 Q SFP+ 4x 10.3 Gbps OM2 Ribbon OFNP 5m 0~70 o C 40GbE Infiniband SDR,QDR,DDR WST - Q SFP+ AOC - C 10 Q SFP+ 4x 10.3 Gbps OM2 Ribbon OFNP 10m 0~70 o C 40GbE Infiniband SDR,QDR,DDR WST - Q SFP+ AOC - C 20 Q SFP+ 4x 10.3 Gbps OM3 Ribbon OFNP 20m 0~70 o C 40GbE Infiniband SDR,QDR,DDR WST - Q SFP+ AOC - C 30 Q SFP+ 4x 10.3 Gbps OM3 Ribbon OFNP 30m 0~70 o C 40GbE Infiniband SDR,QDR,DDR WST - Q SFP+ AOC - C 50 Q SFP+ 4x 10.3 Gbps OM3 Ribbon OFNP 50m 0~70 o C 40GbE Infiniband SDR,Q DR,DDR WST - Q SFP+ AOC - C H0 Q SFP+ 4x 10.3 Gbps OM3 Ribbon OFNP 100m 0~70 o C 40GbE Infiniband SDR,QDR,DDR All specification data are accurate on the date of publication for product comparisons and ordering information. Wavesplitter Technologies, Inc. reserves the right to change specifications without notice. U.S. Branch 2080 Rancho Higuera Ct. Fremont, CA 9 45 3 9, USA Tel: 510 - 651 - 7800 Fax: 510 - 651 - 7822 Taipei Headquarters 16F - 5, No. 75, Sec. 1, Xintai 5th Rd., Xizhi Dist. , New Taipei C ity 221 01 , Taiwan Tel: +886 - 2 - 2 698 - 7208 Fax: +886 - 2 - 2 698 - 7210 ShenZhen Branch 610#, 6F, No.204 Building, 2nd Industrial zone Nanyou, Nanshan district, Shenzhen, Guangdong China 518054 Tel: +86 - 755 - 86265980 Fax: +86 - 755 - 26642741

Views

  • 142 Total Views
  • 76 Website Views
  • 66 Embedded Views

Actions

  • 0 Social Shares
  • 0 Likes
  • 0 Dislikes
  • 0 Comments

Share count

  • 0 Facebook
  • 0 Twitter
  • 0 LinkedIn
  • 0 Google+

Embeds 2

  • 3 www.wavesplitter.com
  • 1 18.220.135.215